Specifications
10
System Maintenance (cant.)
Deleting
Lost
or
Stolen Remote
Controls
from
Your System
If one
of
your remote controls is lost or stolen, follow these instructions
IMMEDIATELY to remove the control code from your system.
1.
Have all remaining remote controls available.
2.
Enter the control programming mode by following steps 1 - 5
of
Adding
Remote Controls
to
Your
System
(page 8).
3a.
If
you
have
only
one
remaining
remote
control,
press the
ARM button on that remote control
eight
(8)
times,
pausing
at
least 1 second between each press. Make sure that the
horn chirps each time you press the ARM button.
3b.
If
you
have
two
remaining
remote
controls,
press the ARM
button on each remote control
four
(4)
times,
pausing at
least 1 second in between each press. Make sure that the
horn chirps each time you press the ARM button.
3c.
tf
you
have
three
remaining
remote
controls,
press the
ARM button on the two remote controls
three
(3)
times,
then
press the ARM button on the remaining remote control
twice.
Pause at least 1 seconds in between each press. Make sure
that the horn chirps each time you press the ARM button.
4. Turn the vehicle ignition off to exit the programming mode.
When you are finished, the
lost or stolen remote control will
no longer operate your system.
Basic
Troubleshooting
This section outlines some
of
the basic issues you may experience
while becoming used to the F60/F65. If you have a problem that is not
covered by this section, please consult your installer.
Symptom Problem Solution
Weak or dead battery
Remote control does
Change battery
not work Remote control not
Program remote
programmed
control (page
9)
Door or other Close entrance
entrance is open
System will not arm Courtesy
light is on Turn courtesy light off
System is in
Valet Turn off Valet mode
mode (page 6)
Hood is open
Close hood
System will not start
Brake is pressed Release brake
101101ยท4 F6Q.65.p65
10
9113101,12:14
PM