F60lF65 Remote Vehicle Control System Car Start, Security and Convenience System IMPORTANT NOTE: The operation of the F60/F65 as described in this manual is applicable 10 most vehicles. However, due to the engine type and configuration of some vehicles (Le. diesel engines), some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your 101101-4 installing dealer for more information. 101101-4 FSD-5S.
Table of Contents Features and Benefits of the F60/F65 ..................................... 4 Using Your RemoteTransmitter .............................................. 5 Arming the Security System Pre-arm Mode Disarming the Security System Attempted Intrusion Identification Disabling the IT_sTM InteriorTheft Sensor ...............................
Features and Benefits of the F60lF65 '"J Two Easy-to-Use Weather-Resistant Remote Controls The remote controls included with the F60/F65 utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the F60/F65 simple to operate.
Using Your Remote Transmitter Press to DISARM sIlCtliity System and Unlock Doors Press to ARM the· Security System and Lock the Doors Press lWlCE for Two-Stage Door Unlock* Press for Car Finder Press START to start the vehicle Press and HoldtoOpenTrunk Press and Hold for Panic Alarm Arming the Security System To arm the system, exit the vehicle, close all doors, then press' the ARM button. The horn will "chirp" twice' and the parking lights will flash twice, indicating the system is armed.
Using Your Remote Transmitter (cant.) Disabling the IT-sTM Interior Theft Sensor It may be necessary at times to disable the IT_sTM Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the ARM button and then press the FIND/PANIC button within two seconds of pressing ARM to disable the interior theft sensor. The horn will chirp three times to indicate that the sensor is disabled.
Using Your Remote Transmitter (cont.) Using Valet Mode If the Passive Arming feature is enabled on your system, Valet mode temporarily prevents the alarm system from arming automatically. This is useful when fueling or servicing your vehicle. To enter Valet Mode: With the vehicle ignition on, press the ARM button. The red dashboard warning light (status indicator) will turn on for one second, then turn off. This indicates that the system is in Valet mode.
Using Your Remote Starter (cont'd) Remote Start Safety Features For safety and security reasons, the F60lF65 will shut off the vehicle during remote start if any of the following occur: • The vehicle hood is opened • The brake is pressed before the vehicle ignition is turned on with the key • The engine reaches 3 times its normal idle' • The alarm is triggered As a safety precaution, the vehicle will shut off if left unattended for 12 or 25 minutes, depending on the time preset by your installer.
Automatic Convenience Options The F60/F65 performs a variety of automatic functions to enhance security and comfort. Some of these features are programmable at the time of installation. Please see your installer for further details. Illuminated Entry When the alarm system is disanmed, the vehicle courtesy lights will tum on for 1 minute, or until the vehicle is started or the system is re-armed. Automatic Arming The F60/F65 will arm automatically 1 minute after the ignition is turned off.
~~~~~M~a~in~t~e~n~a~n~c;e~~~~~~~~~~~~~'9 Changing the Remote Control Battery The 12-volt alkaline battery supplied in your remote transmitter should last approximately one year, depending on usage. When the battery begins to weaken, you will notice a decrease in range, or the distance from your vehicle that your remote transmitter will operate. Follow the instructions below to change the remote transmitter battery. Open Back of Remote TlP,:psmitter 1.
System Maintenance (cant.) Deleting Lost or Stolen Remote Controls from Your System If one of your remote controls is lost or stolen, follow these instructions IMMEDIATELY to remove the control code from your system. 1. 2. Have all remaining remote controls available. Enter the control programming mode by following steps 1 - 5 of Adding Remote Controls to Your System (page 8). 3a.
Emergency Disarm Procedure If your remote control is lost or fails to function, use this procedure to disarm the F60/F65 and start your vehicle. 1. Use the keys to enter the vehicle. The alarm will sound once the door is opened. 2. Insert the key into the ignition and turn to the ON position. 3. Locate and press the emergency override button. The alarm will turn off and then you will be able to start your vehicle.
System Layout IMPORTANT!!! The module MUST be programmed before it will operate. Refer to the programming instructions on pages 13-16. Wire End View ~ ~ Ii: 101101-4 F6D-65.
Programming Selectable Options Note: Transmitters must be programmed prior to these steps. 1. Repeat steps 1·4 of Adding Remote Controls to your System (page 9). 2. Press and release the emergency override button. The horn will sound four (4) times. This indicates that the unit has entered the Key/ess Options Programming mode. 3. Press the Find/Panic button to advance to the next feature. The horn will sound a number of times to indicate the number of the option. 4.
Programming Selectable Options (cont'd) 14 Adjusting the Onboard IT-sTM Interior Theft Sensor The IT-sT" is factory pre-set at a moderate sensitivity level and has two adjustment points: Ute-Touch and Full Shock. ~ Adjusting Lite-Touch Sensitivity: 1. To program the sensitivity of the lite touch trigger, simply enter into the installer options bank, then advance to the Ute Touch Adjustment.
~~===15 Programmable Options Chart Default settings in BOLD Pplr.9.lir~l!dli:rQl}.~:;.iAlqll!fpE·(7(iiyjj~~~Qp(@sJ2~~~\i'iI~TllS'itN[)lc~tOf\ij 1. Lockwilhlgnrnon 2. Delayed Door Lock 3. Extended Locks 4. Unlock with Ignition 5. Double Unlock Pulse 6. Conlirmation Chirps 7.SilentChoice DoorsbckwhenaHdoo!Saredosedard ignition is turned on 3 sec. delay locking for theater dimming Lock duration is (1) 5 sec. or (2) 0.6 sec. Doors Unl()qkwh~n ·ignftiohi. turned off .
CODE-ALARM,INC.3-YEAR WARRANTY A CODE-ALARM, INC. ("CODE") vehicle security system sold to a retail consumer purchaser by an authorized dealer of CODE and instaJled by an authorized dealer of CODE is warranted by CODE to the original retail consumer purchaser to be free from defects in workmanship and materials for the lifetime of the vehicle in which the security system was originally installed.
CODE-ALARM, INC. Theft Protection Plan The Theft Protection Program is designed to provide the retail purchaser of a security system provided by CODE-ALARM, INC. ("CODE") an additional benefit, at no additional cost to the purchaser, should their vehicle be stolen while protected by a CODE-ALARM security system. While CODE has created this program as a way of showing appreciation to its customers.
