Installation manual

I/O Control Parameters
90 S1A53838 09/2011
Logic Inputs Functions
See table on page 91 for a complete list of F, R and RES logic inputs assignments
Code Name / Description Adjustment range Factory setting
F111 [LI F selection]
F Logic Input Function 0 to 73 2
The setting of parameter F111 determines the control function of logic input terminal F.
F112 [LI R selection]
R Logic Input Function 0 to 73 6
The setting of parameter F112 determines the control function of logic input terminal R.
F113 [LI RES selection]
RES Logic Input Function
0 to 73 10
The setting of parameter F113 determines the control function of logic input terminal RES.
F109 [VIA selection]
VIA Input Function (Analog or Logic Selection)
-0
DANGER
UNINTENDED EQUIPMENT OPERATION
Prevent accidental grounding of logic inputs configured for sink logic. Accidental grounding can result in unin-
tended activation of drive functions.
Protect the signal conductors against damage that could result in unintentional conductor grounding.
Failure to follow these instructions will result in death or serious injury.
0
1
2
[AI]: Analog input
[LI sink]: Logic input - sink (negative logic)
[LI source]: Logic input - source (positive logic)
The setting of parameter F109 determines whether control input terminal VIA will serve as an analog input (0-10 Vdc or 0–
20 mA) or as a logic input (either sink or source).
When configuring VIA as a logic input, be certain to slide switch SW100 on the main control board to the V (voltage) position.
When configuring VIA as a logic input using sink (negative) logic, be certain to connect a 4.7 k
Ω (1/2 W) resistor between control
terminals P24 and VIA.
For more information on the use of control input terminal VIA, see ATV212 Installation manual.
F118 [VIA LI selection]
VIA Logic Input Function 0 to 73 7
Set first parameter [VIA selection] (F109) before setting parameter F118. The setting of parameter F118 determines the
control function of logic input terminal VIA.
See page 91
for a complete list of VIA logic input assignments.