Installation manual

Overview
S1A53838 09/2011 23
Run Mode
To access the Run mode, press the MODE key until the drive operating frequency, a detected fault code, or a
pre-alarm code is displayed.
See Diagnostics and troubleshooting beginning on page 149
for the detected fault and pre-alarm codes.
Changing the Display in Run Mode
Motor operating frequency is the default value displayed on the graphic terminal in Run mode. This displayed
value can be changed by setting parameter [Displayed param.] (F710). See page 120
for a list of the display
choices.
The displayed value can be expressed as a percentage of the drive rating, or in amperes or volts, as appropriate
for the value displayed. The units can be changed by setting parameter [Unit value selection] (F701) (see
page 120
).
In addition, the resolution of the speed reference and output frequency displays can be adjusted by setting
parameters [Loc. speed ref. step] (F707) and [Display ref. resol.] (F708) (see pages 77
and 120).
Programming Mode
Use this mode to program the drive.
To access the Programming mode, use the MODE key until the PRG indicator LED on the display is illuminated.
See Menu Navigation page 24
.