Installation manual

Overview
22 S1A53838 09/2011
Detected fault History
I/O Map
In both the monitoring mode and the detected fault history, it is possible to view the state of the logic inputs and
the relay outputs. See previous tables on pages 20
and 21.
Logic Input Map
The ON or OFF status of each logic input is displayed in bits. VIA is included in this display if parameter F109
is set to either 1 or 2.
Relay Output Map
The ON or OFF status of each relay output is displayed in bits.
Display Display on graphic terminal Description
n2
[Comm. counter 1] Number of times in succession that this particular detected fault has oc-
curred
o60.0
[Motor frequency] Motor operating frequency, displayed either as Hz or in custom unit set by
parameter [Customized freq val] (F702)
Fr-F
[Direction]
Fr-F = [Forward]
Fr-r = [Reverse]
F60.0
[Speed reference] Command frequency to drive, displayed either as Hz or in custom unit set
by parameter [Customized freq val] (F702)
C80
[Motor current] The average of the 3 phases of motor current displayed either as A or as a
percentage of the drive's nameplate-rated output current. Select % or A
with parameter [Unit value selection] (F701).
Y100
[Line voltage] The average of the 3 phases of line to line input voltages displayed either
in volts or as a percentage of the drive's rated input voltage (200 V for
208/240 V models - 400 V for 480V models). Select % or volts with param-
eter [Unit value selection] (F701).
P100
[Motor voltage] The average of the 3 phases of line to line output voltages displayed either
in volts or as a percentage of the drive's rated output voltage (200 V for
208/240 V models - 400 V for 480 V models). Select % or volts with param-
eter [Unit value selection] (F701).
..11
[LOGIC INPUT MAP]
Logic input map The bar representing VIA is
displayed only if
F109 =1or2
0.1
[Relay map]
t0.10
[Drive run time 100h] Cumulative drive run time. 0.01 = 1 hour. 1.00 = 100 hours
ON:
OFF:
VIA
F
R
RES
ON:
OFF:
RYA-RYC
FL
ON:
OFF:
VIA
F
R
RES
ON:
OFF:
RYA-RYC
FL