Installation manual

Overview
20 S1A53838 09/2011
Monitoring Mode
The Monitoring mode displays drive operational data in real time. To access the Monitoring mode, press the
MODE key until the MON LED is illuminated. Then use the UP and DOWN keys to view up to 30 different types
of data.
Monitoring Mode Displays
ENT
RUN
PRG
MON
%
Hz
Loc
Rem
RUN
STOP
RESET
E
N
T
RUN
PR
G
MO
N
%
Hz
Loc
Re
m
RU
N
S
T
O
P
RE
S
E
T
MODE
Fr-F
AUF
0.0
MON
C80
t0.
n---
F60.
25 other
parameters
PRG
RUN
MODE
MODE
MODE
0
10
Display
example
Display on graphic terminal Description
Fr-F
[Direction]
Fr-F = [Forward]
Fr-r = [Reverse]
F60.0
[Speed reference] Command frequency to drive, displayed either as Hz or in custom unit set
by parameter [Customized freq val] (F702)
C80
[Motor current] The average of the 3 phases of motor current displayed either as amperes
or as a percentage of the drive's nameplate-rated output current. Select %
or A with parameter [Unit value selection] (F701).
Y100
[Line voltage] The average of the 3 phases of line to line input voltages displayed either
in volts or as a percentage of the drive's rated input voltage (200 V for
208/240 V models - 400 V for 480 V models). Select % or volts with param-
eter [Unit value selection] (F701).
P100
[Motor voltage] The average of the 3 phases of line to line output voltages displayed either
in volts or as a percentage of the drive's rated output voltage (200 V for
208/240 V models - 400 V for 480 V models). Select % or volts with param-
eter [Unit value selection] (F701).
q60
[Motor torque %] Estimated motor torque as a percentage of the motor's rated torque
c90
[Torque current] The average of the 3 phases of torque-producing motor current displayed
either as amperes or as a percentage of the motor's rated torque-producing
current. Select % or A with parameter [Unit value selection] (F701).
L70
[Drive load %] The motor current as a percentage of the drive's rated output current, which
may be reduced from the drive’s nameplate current rating by adjustments
in switching frequency.
h80
[Input power KW] drive input power displayed in accordance with parameter [Power cons.
unit] (F749).
H75
[Output power KW] drive output power displayed in accordance with parameter [Power cons.
unit] (F749).
o60.0
[Motor frequency] Motor operating frequency, displayed either as Hz or in custom unit set by
parameter [Customized freq val] (F702)
..11
[Logic input map]
The bar representing VIA is dis-
played only if F109 = 1 or 2
ON:
OFF:
VIA
F
R
RES