Installation manual

Overview
18 S1A53838 09/2011
Embedded display terminal
This section describes the features of the integrated display terminal.
Embedded display terminal features
An optional graphic display option (VW3A1101) is also available.
RUN
PRG
MON
%
Hz
Loc
Rem
RUN
STOP
RESET
MODE
ENT
13
1
2
3
6
7
4
5
9
10
11
14
12
8
LED/Key Characteristics
1 Display RUN LED Illuminates when a run command is applied to the drive.
Flashes when there is a speed reference present with a Run command.
2 Display PRG LED Illuminates when Programming mode is active.
Flashes in AUF, GrU modes
3 Display MON LED Illuminates when Monitoring mode is active.
Flashes in detected fault history display mode
4 Display unit 4 digits, 7 segments
5 Display unit LED The % LED illuminates when a displayed numeric value is a percentage.
The Hz LED illuminates when a displayed numeric value is in hertz.
6 UP/DOWN keys Depending on the mode, you can use the arrows to:
Navigate between the menus
Change a value
Change the speed reference when the UP/DOWN LED (7) is illuminated
7 UP/DOWN LED Illuminates when the navigation arrows are controlling the speed reference
8 Loc/Rem LED Illuminates when Local mode is selected
9 MODE Press to select the embedded display terminal mode.
Run mode (default on power-up)
Programming mode
Monitoring mode
Can also be used to go back to the previous menu.
10 Loc/Rem Switches between Local and Remote modes
11 ENT Press to display a parameter’s value or to save a changed value.
12 RUN LED Illuminates when the Run key is enabled
13 RUN Pressing this key when the RUN LED is illuminated starts the drive.
14 STOP Stop/reset key.
In Local mode, pressing the STOP key causes the drive to stop based on the setting of parameter [Loc.
mot stop mode] (F721).
In Remote mode, pressing the STOP key causes the drive to stop based on the setting of parameter
[Ext. fault stop Mode] (F603). The display will indicate a flashing “E”.
If [HMI reset button] (F735) is set to 0, pressing the stop key twice will reset the drive, if the detected
fault condition has been cleared.