Installation manual

Parameters Reset Tables
164 S1A53838 09/2011
F483
[In noise inhibit gain] –100
F484
[Pwr supply adj. gain] –0.0
F485
[Stall control coef. 1] –100
F492
[Stall control coef. 2] –100
F495
[Motor voltage coef.] %104
F496
[PWM adj. coef.] kHz 14.0
F502
[Acc/dec 1 pattern] –0
F503
[Acc/dec 2 pattern] –0
F504
[Ramp switching] –1
F505
[Commut. ramp freq.] Hz 0.0
F506
[Acc/Dec S-pat start] %10
F507
[Acc/Dec S-pat end] %10
F602
[Drive fault memory] –0
F603
[Ext. fault stop Mode] –0
F604
[DC brk time ext flt] s1.0
F605
[Output phase loss] –3
F607
[Mot overload time] s300
F608
[Input phase loss] –1
F609
[Underload band] %10
F610
[Underload det.] –0
F611
[Underload level] % / A 0
F612
[Underload det. time] s0
F613
[Short circuit det.] –0
F615
[Overtorque det.] –0
F616
[Overtorque level] %130
F618
[OvTorque det time] s0.5
F619
[Overtorque band] %10
F621
[Run time alarm] h 610.0 (6100 h)
F627
[Undervolt detect.] –0
F632
[Mot overload memo] –0
F633
[Loss of VIA] %0
F634
[Amb. temp. alarm] –3
F645
[Mot PTC selection] –0
F646
[PTC resistor value]
Ω
3000
F650
[Forced fire control] –0
F691
[AO slope] –1
F692
[Analog output bias] %0
F700
[Parameter lock] –0
F701
[Unit value selection] –1
F702
[Customized freq val] –0
F703
[Frequency convert.] –0
F706
[Customize unit bias] Hz 0.0
F707
[Loc. speed ref. step] Hz 0.0
F708
[Display ref. resol.]
–0
F710
[Displayed param.] –0
F721
[Loc. mot stop mode] –0
Parameter Description Unit Default Value