Installation manual
Parameters Reset Tables
162 S1A53838 09/2011
Parameter values that do not vary by reset type
The table below lists the parameters whose values, after a reset, do not vary by the reset type.
To determine the value of a parameter after a reset, locate the parameter in the first column and read across the
row to the default value column. The number that appears at the intersection of the parameter and the default
value is the parameter’s value after a reset of any type ([Parameter reset] (tYP) = 1, [Parameter reset] (tYP)
= 2, or [Parameter reset] (tYP) = 3).
Parameters whose values after a reset do not vary by reset type
Parameter Description Unit Default Value
AU1
[Auto ramp] –1
AU4
[Auto set function] –0
FMSL
[AO funct. selection] –0
FM
[AO scaling] ––
tYp
[Parameter reset] –0
Fr
[Local mot. direction] –0
FC
[Local speed ref.] Hz 0.0
LL
[Low limit frequency] Hz 0.0
Pt
[Mot cont. mode sel.] –1
OLM
[Motor overload prot] –0
Sr1
[Preset speed 1] Hz 15
Sr2
[Preset speed 2] Hz 20
Sr3
[Preset speed 3] Hz 25
Sr4
[Preset speed 4] Hz 30
Sr5
[Preset speed 5] Hz 35
Sr6
[Preset speed 6] Hz 40
Sr7
[Preset speed 7] Hz 45
F100
[Freq. 1 reached] Hz 0.0
F101
[Freq. 2 reached] Hz 0.0
F102
[Freq.2 bandw.] Hz 2.5
F108
[Logic Funct 1 active] –0
F109
[VIA selection] –0
F110
[Logic Funct 2 active] –1
F111
[LI F selection] –2
F112
[LI R selection] –6
F113
[LI RES selection] –10
F118
[VIA LI selection] –7
F130
[RY Relay Function 1] –4
F132
[FL Relay Function] –11
F137
[RY Relay Function 2] –255
F139
[RY logic select.] –0
F167
[Freq band det range] Hz 2.5
F200
[Auto/man speed ref]f –0
F201
[VIB ref. point 1] %0
F202
[VIA freq. point 1] Hz 0.0
F203
[VIA freq. point 2] %100
F207
[Remote spd ref 2] –2
F210
[VIB ref. point 1] %0