Installation manual

Setup
14 S1A53838 09/2011
Steps for setting-up the drive
2. Apply input power to the drive, but do not give a
run command.
3. Configure
v the nominal frequency of the motor
[Parameter reset] (tYP) = [50 Hz reset] (1)
if this is not 50Hz,
v the motor parameters, page 66, only if the
factory configuration of the drive is not
suitable,
v the application functions in the Drive Control
Parameters section, page 77
and the I/O
Control Parameters section, page 89
, only if
the factory configuration of the drive is not
suitable.
1. Please, refer to the installation manual..
PROGRAMMING
INSTALLATION
Tips:
z Before beginning programming, complete the customer
setting tables, page 171
.
z Perform an auto-tuning operation to optimize performance,
page 71
.
z If you get lost, return to the factory settings, page 62.
4. Adjust the application parameters
v [Acceleration time 1] (ACC), page 83
and [Deceleration time 1] (dEC),
page 83
.
v [Low limit frequency] (LL), page 82
and [Upper limit freq] (UL), page 82
.
v [Motor thermal prot.] (tHr), page 70.
5. Start the drive