Installation manual

ManualsBrandsCode Alarm ManualsAutomotiveF60

100

I/O Control Parameters

100 S1A53838 09/2011

[Manu reset flt.]

Non-autoresettable detected fault

OFF: None of the detected fault conditions listed below exist

ON: One (or more) of the following detected fault conditions exists and has

stopped the drive:

• E – external detected fault

• E-18 – VIA analog input signal detected fault

• E-19 – main control board CPU communication

• E-20 – excessive torque boost

• E-21 – main control board CPU detected fault 2

• EEP1 – main control board EEPROM detected fault 1

• EEP2 – main control board EEPROM detected fault 2

• EEP3 – main control board EEPROM detected fault 3

• EF2 – ground detected fault

• EPH0 – output phase detected fault detection

• EPH1 – input phase detected fault detection

• Err1 – speed reference

• Err2 – main control board RAM

• Err3 – main control board ROM

• Err4 – main control board CPU detected fault 1

• Err5 – serial communication control

• Err7 – motor current sensor

• Err8 – serial communication network

• Err9 – graphic display option communication interruption

• Etn1 – auto-tuning

• EtYP – drive ratings

• OCA – short-circuit detected in drive output inverter stage

during motor startup

• OCL – short-circuit detected in motor or output wiring during

motor startup

• OH2 - external overheating

• Ot – overtorque

• Uc – underload

• UP1 - Undervoltage

[Inv manu reset flt.]

Inversion of Manu reset flt. function

OFF: One (or more) of the following fault conditions exists and has stopped

the drive: