Setup guide
Dedicated Micros ©2007
93
BX2
Sequencing Cameras
Sequence
Press the Sequence button to toggle the main monitor sequence on or off.
Press and hold the Sequence button to edit the sequence.
Use the camera buttons to include or remove cameras from the sequence.
Press MODE/MENU to exit.
Note:
The spot monitor sequence can only be activated or edited in spot mode.
Viewing Cameras on the Spot Monitor
Press the MODE/MENU button to toggle ‘spot’ mode, indicated on the main monitor and the front panel LED.
Press a camera button to display that camera on the spot monitor or tap the sequence button to sequence the
cameras.
Viewing across a network
The unit can use either a Web interface or network viewing software to view images across the network.
The network viewing software can be downloaded directly from the unit onto your local PC using the network
connection, see ‘Downloading the Viewer from the Unit’ for details.
The recommended PC specication for viewing images over a network is:
• Pentium IV, 1.8GHz processor.
• 256MB RAM.
• 8MB of Video RAM.
• 16 Bit sound card for audio support
• 1024 x 768 x 32bit colour monitor (min).
• 10/100Mbit Ethernet half duplex network interface card.
• Windows 2000, Windows XP.
• Internet Explorer 6 or Netscape Navigator 7.1.
Although the system will operate on lower specication computers this standard will provide high performance
video quality and update rates. If lower specication processors are used this will affect the overall performance
of the computer.
Downloading the Viewer from the Unit
Connect to the DVR to download the Viewing application:
1. Open your web browser on your PC.
2. Enter the IP address of the DVR in the ‘Address’ box of Internet Explorer or Netscape and
press Enter. Remove all preceding 0’s, i.e. 123.123.123.001 in the DVR should be entered as
123.123.123.1 in the web browser.
The unit needs a valid IP address and Subnet mask to allow access across the network. This can be congured in
the ‘Network Settings’ menu, described later in the manual.