Setup guide

BX2

VMD Grid

The VMD grid covers 16 default areas of the screen, it is possible to congure the grid to only cover the areas of

interest.

Note: Ensure the camera to be congured has been selected prior to highlighting the Setup option.

When Setup is selected a prompt is displayed. Follow the instructions on screen to congure this option.

To edit the grid;

1. Move the ‘*’ to the start point of the zone to be created. Use the 7 and 8 buttons to move between

the default zones.

2. Press Camera 1 to switch to ‘drawing’ mode and to automatically delete the existing (if applicable)

zone (see on-screen text to check the drawing option is selected).

3. Use the arrow keys to move to the end point for the zone (this will be diagonally opposite the

start point to create a box).

4. Press Camera 1 to take the unit out of the drawing mode.

5. You can press Camera 2 to cycle through the modes available and select the mode that is to be

applied to the created zone. This is the same as setting the VMD Zone mode.

Use direction keys to navigate grid

Use Camera 1 key to set selected zone

Use camera 2 key to cycle through zone modes

Use << and >> to change between zones

Press MENU/MODE key to start setup

Press MENU/MODE key again to exit grid

VMD Test

Once the VMD Camera Settings have been congured, it is possible to test the conguration. When Walktest is

selected, a prompt will be displayed. Follow the on-screen instructions. If the settings are not satisfactory, adjust

the settings and then carry out the walktest again.

Note: If the Walktest fails consistantly, check that the Nuisance Count and Stuck Time settings (within

General Contacts) are suitable for this operation.

Press MENU/MODE key to start walktest

Press MENU/MODE key again to exit