Setup guide

Dedicated Micros ©2007
76
BX2
Type
The unit can recognise a range of IP cameras as well as digital video feeds from NetVu Servers. These include;
NetVu Server
Axis 2120
Axis 211
Axis 2140
AL9710
JVC VN-C20
JVC VN-C625
JVC VN-C655
Note:
Other cameras utilising the same stream/telemetry protocol as those listed above
will also be supported.
URL
Enter the IP address that will send the IP stream
Port
Enter the port number to be used for this stream.
Camera Number
If a NetVu Server is being used, this parameter will specify which camera number from the Server will be used to
provide the stream.
FPS
Enter the frames per second that the camera has been set to deliver.
Colour Adjust
When the colour bar is selected, press to reduce, and to increase the colour.
Note: This option is not displayed if the camera is set as monochrome.
Contrast Adjust
When the contrast bar is selected, press to reduce, and to increase the contrast.
Camera Video Input
This option is only displayed when a camera has failed or is ofine. Select disconnect whilst the camera is ofine
to prevent the camera fail message and alarm being triggered.
If the video input is not to be monitored for camera failure select Connected - Ignore cam fail.
Tip: This menu can be entered directly by pressing and holding a camera button.
Telemetry
The unit supports control of coaxial and serial telemetry. This option allows the connected dome/PTZ camera to
be congured.
Ensure the serial type has been selected in the ‘Serial and Telemetry’ menu. This option then allows these
settings to be allocated to specic video inputs.