Setup guide

Dedicated Micros ©2007
7
BX2
CE Mark
If this product is marked with the CE symbol it indicates compliance with all applicable directives.
Directive 89/336/EEC.
A ‘Declaration of Conformity’ is held at Dedicated Micros Ltd.,
11 Oak Street, Swinton, Manchester M27 4FL.
Laser
The unit supports an integrated CD writer, the following are additional warnings associated with installing and
operating the CD writer, please pay particular attention to this information.
Caution - Use of controls or adjustments or performance of procedures other than those specied herein may
result in hazardous radiation exposure.
• To prevent exposure to laser emanations (harmful to the eyes), do not attempt to disassemble this unit.
Installing the hard disk caddies
The hard disk caddies are packaged separately to the main unit during transit.
The caddies will need to be tted into the BX2 before the unit is powered.
1. Ensure the BX2 is in its nal position before attempting to t the caddies.
2. Remove the caddies from their boxes, and locate the disk number labels, disk 1 to disk 4.
3. Press the front panel to open the front ap.
4. Slot the caddies into the disk bays (with the disk label face up) as below:
To t the hard disk caddies:
Warning: The BX2 will not operate if the caddies are tted into the incorrect bays.
Disk 1 (Drive C) Disk 3 (Drive E)
Disk 2 (Drive D) Disk 4 (Drive F)
5. Once the caddy is fully inserted into the bay, use the supplied key to lock the caddy into place.
6. To complete the installation, connect the cameras and monitors as advised in the Quick Install
page (page 6).