Setup guide

BX2

System Logs

There are a number of system logs supported on the unit, these logs can be viewed and used for Administration

purpose.

Each log requires enabling to ensure entries are created by the unit, refer to the Networking Guide for details on

how to enable and view the system logs.

Note: If a log is not enabled, the option to view this log will not be displayed within this menu.

PPP connections

Anonymous FTP connections

Illegal file access

Telnet / FTP users

Archive

Logfile

Email Log

Sent message log

Disabled

View

Disabled, Enabled, View

ystem Lo

Status Page

It is possible to switch the status page off on the unit.

The status page will detail any alarms on the system, camera failure, main storage (protected) and the earliest

unprotected recording.

Registration

All necessary conguration and registration is carried out by the manufacturer at the factory. This page is used

for fault diagnosis only and should not be enabled unless advised by Dedicated Micros Technical Support.

LCD Contrast Adjust

The contrast on the front panel LCD can be adjusted to suit the room lighting, use the up and down cursor to

increase or decrease the LCD contrast.