Setup guide

BX2

System Options

Unit number

System name

Factory default

System resolution

IR Receiver

Serial & telem ports

System logs

Status page

Registration

LCD contrast adjust

XXX

Reset

704x512

Enabled

Edit

01 - 16

Enabled, Disabled

ystem

ption

Unit number

When multiple units are connected together via the 485-bus, a unit number must be set to identify each unit.

Note: Modifying the unit number will disable control via a remote keyboard. The new unit number

should be selected to regain control of the unit.

System Name

Each unit can be allocated a relevant 20 character name to identify the unit to the Operator or System

Administrator.

Factory Default

This will switch the majority of the settings back to factory default. However hardware specic settings such as

the IP address, camera termination, etc. will remain unchanged.

System Resolution

This is the fundamental resolution for the system and will be used as the basis of all the congurable resolution

parameters described in this document.

The supported system resolutions are: 640x512, 704x512, 720x512, 640x576 704x576 or 720x576.

IR Receiver

If multiple units are being controlled from the same IR remote control, it is necessary to disable the IR reception

on all but one unit to allow communication between the handset and the system.The remote control mimics

the front panel control of the unit and allows control of a single or multiple units (use the unit select option).

However the remote control does not allow the conguration of the menus, or control of telemetry cameras.

When the IR receiver is enabled the IR LED on the unit is solid green, when it is disabled the IR LED switches to

solid amber. The LED ashing green signies an IR signal being received.