Setup guide

BX2

NOTE: The IP address used to dial in to the unit is the IP address used for PPP_Link2.The PPP IP address

used in System Options->Network Settings->PPP Selection is the base PPP IP Address. The dial in

address is one greater than this. Ie if the PPP IP address is dened as “10.0.0.1”, the PPP IP address

required to connect to the unit is “10.0.0.2”.

The unit will request a username and password, as dened in the ‘proles’ conguration le. The default settings

are ‘username’ and ‘password’.

NOTE:

The Username and Password should be changed to maintain security. This is done by editing

the ‘proles’ conguration le on the unit. For full details on how to do this, see the Networking

Guide, which can be downlaoded from the unit’s web pages (See Operator Reference section)

Dial out

To make an outgoing PPP connection (to send an email), ensure the unit has been congured to send an email

under specic conditions, that the correct telephone number has been entered in the proles le, and that this

prole has been congured in the email settings. Email settings are congured using the embedded web pages

and the process is explained in the Networking guide..