Owner's Manual

INSTALLATION GUIDE FOR THE:
DA-2
DA-2 Power Door Lock Actuator
Printed in Taiwan Form No. DA-2
DOOR LOCK ACTUATOR INSTALLATION
1.) Carefully remove the door panel.
2.) Mount the actuator to the vehicle's door
in a postion that will allow the actuator's connecting rod to freely move the
vehicle's locking rod. Ensure the placement
of the actuator does not inhibit window movement or door panel replacement.
3.) Slide the actuator connecting rod into the connecting rod clamp and tighten.
4.) Set door lock
in the unlock position.
5.) Pull actuator connector rod until the actuator is fully extended, then tighten connecting rod clamp to existing factory door
rod.
6.) Wire the actuator as illistrated below. When using a keyless entry system with
on board relays, refer to the systems
manual for wiring instructions.
87
,..-_---. __ ---j Fused +12 Volt
Battery Source
GREEN INPUT 1----------
( - ) Module Lock Output
11+--------1 (-) Module Unlock Output I
87
86
86
,..--- .... ---1 Fused +12 Volt
Battery Source
BLUE INPUT