User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 45 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
150
Background Bluetooth
®
Connection
(synchronousSend)
0
0: Bluetooth
®
connection is confirmed before user is allowed
to scan. Pressing the trigger button will cancel the
connection.
1: Allows user to begin scanning before the Bluetooth
®
connection is confirmed.
Allows user to begin scanning before Bluetooth
®
connection
is confirmed
Note: supported in firmware version 3430+
Also see registers: 151, a0
151
Beep before Bluetooth
®
Connection is established
(quickConnectNotWaitForCo
nnection
0
0: Beep upon establishing a Bluetooth
®
Connection
1: Do not wait for connection before beep.
Give the second beep before connection is established when
scanning QuickConnect code. To be used with register 150 to
improve user experience with QuickConnect code
Note: supported in firmware version 3430+
Also see register: 150
154
Enable Black and White
Pictures
(takeBlackAndWhitePicture)
0
0: Images remain in grey scale.
1: Captured images are converted to black and white.
Converts grey scale images to black and white
Note: supported in firmware version 3430+
159
Ignore Duplicate Code
(duplicateBlockTime_msec)
0
Valid Range: 0 (off) to 7FFFFFF Milliseconds
Consecutive duplicate codes (i.e., codes that contain the same
data) are blocked for this amount of time (in milliseconds).
The actual block time is the sum of settings d6*1000+159.
Note: Supported in firmware CR1200 version 4112+,
CR2/CR2 version 3430+
Also see register: d6
172
Automatically Save Active
RF Connection Bluetooth
®
Address
(rfAutoSaveActiveConnect)
CR2/3: 0
0: Disable
1: Enable
Automatically save the RF connection address. The address
in the QuickConnect code will be saved if enabled.
Other communication settings such as RF one-way or RF
two-way are not automatically saved, so the Reader must be
saved in the proper communication mode for this feature to
work properly.
Note: Supported in firmware version 3474+