User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 43 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
106
Display black mode gray
scale settings
(lcdBlackMode)
9999
Valid Range: (each digit): 0 to 9
For all gray scales, each digit (4 bits) divided by 9 represents
the percent of time a pixel of the corresponding gray scale is
turned on in each frame. The lowest 4 bits correspond to
frame 1, next 4 to frame 2, etc.
Note: Supported in firmware version 2526+
10b
Enable JavaScript
(enableJavaScript)
1
0: Disable
1: Enable
When set to 0 installed scripts are disabled. This can be useful
from boot mode for recovering the unit if a non-responsive
script is installed.
Note: supported in firmware version 2526+
10c
RF Connected Cache Time
(rfConnectedCacheTime_sec
)
3
Valid Range: 0 to 7FFFFFFF Seconds
The time the last connection status received from the radio
remains valid.
If a request is made during this time since last radio query, the
cached status is returned. Otherwise, the Reader will query the
radio for connection status (which takes up to 1 second).
10d
Data Matrix Symbol Size
(dataMatrixSymbolSize)
CR2/CR3: 0
CR1200: 2
0: Normal effort (Default)
1: Increase effort
2: Max effort
Increases the decoder’s effort to find a Data Matrix symbol in
an image.
Note: supported in firmware version 3100+
Also see register 1b2
10e
Legacy Picture Upload
(legacyPictureUpload)
1
Selection of picture upload method:
0: Store pictures as files – Pictures will be stored as files and
must be uploaded using the “^” command. Take-picture event
will store rather than immediately upload picture.
1: Legacy picture upload – Take-picture event will attempt to
immediately upload picture using the legacy image upload
protocol. (If upload fails, the picture will be stored as a file.).
Also, the ‘X’ command will cause stored picture files to be
uploaded using the legacy image upload protocol. (The
images will not be automatically transferred when a
connection is established; the ‘X’ command is needed.)
Note: supported in firmware version 3100+