User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 42 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
fc
Keep reading codes as long
as button is held down
(keepReadingWhileButtonIs
Pressed)
0
0: Disable (requires button to be released before next scan
occurs)
1: Enable
Note: when enabled, duplicateBlockTime_sec should be set
to be greater than zero.
fd
log battery level and
timestamp
(logBatteryLevel)
0
Valid Range: 0 (off) to FFFFFFFF
Number of scans between each log entry that includes the
battery level and the timestamp
100
Backlight Timeout
(backlightTimeout_ms)
BB8
(#3000)
Valid Range: 0 to 7FFFFFFF Milliseconds
Backlight goes off automatically after this amount of time, in
milliseconds, after a button press.
Note: Supported in firmware version 2526+
101
Backlight Brightness
(backlightBrightness_percent
)
4B
(#75)
Valid Range: 0 to 64 (#100) Percent
Backlight is illuminated at this percent value
Note: Supported in firmware version 2526+
102
Keypad beep volume
(keypadBeepVolume_percent
)
0
Valid Range: 0 to 64 (#100) Percent
Beeps at specified percentage of full beeper volume whenever
a keypad key is pressed
Note: Supported in firmware version 2526+
103
Display white mode gray
scale settings
(lcdWhiteMode)
0000
Valid Range: (each digit): 0 to 9
For all gray scales, each digit (4 bits) divided by 9 represents
the percent of time a pixel of the corresponding gray scale is
turned on in each frame. The lowest 4 bits correspond to
frame 1, next 4 to frame 2, etc.
Note: Supported in firmware version 2526+
104
Display light gray mode gray
scale settings
(lcdLightGrayMode)
0097
Valid Range: (each digit): 0 to 9
For all gray scales, each digit (4 bits) divided by 9 represents
the percent of time a pixel of the corresponding gray scale is
turned on in each frame. The lowest 4 bits correspond to
frame 1, next 4 to frame 2, etc.
Note: Supported in firmware version 2526+
105
Display dark gray mode gray
scale settings
(lcdDarkGrayMode)
9996
Valid Range: (each digit): 0 to 9
For all gray scales, each digit (4 bits) divided by 9 represents
the percent of time a pixel of the corresponding gray scale is
turned on in each frame. The lowest 4 bits correspond to
frame 1, next 4 to frame 2, etc.
Note: Supported in firmware version 2526+