User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 40 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
e2
imagerResolution
0
0: SXGA (1280x1024)
1: VGA (640x480)
Note: Error beeps (6 beeps) if in a programming code.
e3
button1ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
The button must be pressed and held for this amount of time
(without change in which buttons are held down) before the
button press is accepted. Setting this value greater than zero
makes it easier to select combinations of buttons (e.g.,
button3, which is button1 and button2 pressed together).
e4
button2ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
e5
button3ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
e6
button4ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
e7
button5ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
e8
button6ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
e9
button7ConfirmationTime_m
s
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
ea
Reconnect Timeout
(reconnectTimeout_sec)
5A
(#90)
Valid Range: 0 to 7FFFFFFF Seconds
See register c6 for the list of settings.
eb
Maximum Reader to Host
packet data size
(maxPacketSize)
4000
(#16384)
Valid Range: 1 to 4000 (#16384)
ec
Host Acknowledgement
Time Limit Multiplier
(HostAckTimeoutMultiplier_
ms)
F
(#15)
Valid Range: 0 to 7FFFFFFF Milliseconds
When commExpectResponse (register 42) is nonzero, the
Reader will wait up to HostAckTimeout_ms + dataSize *
HostAckTimeoutMultiplier_ms milliseconds to receive an
acknowledgement from the Host.
ed
Prefix Result with AIM
Symbology Identifiers
(enableSymbologyIdentifierP
refix)
0
0: don’t prefix with AIM identifier
1: prefix decode result with ISO/IEC standard 15424/AIM
symbology identifier
f0
Allow Code 128 Short
Margin
(allowCode128ShortMargin)
1
0: Disable
1: Enable