User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 39 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
c7
SXGA Far Field Window
Vertical Size
(farFieldDecodeWindowWid
th_pixels)
CR2/CR3: 280
(#640)
CR2500/CR3500:
280
(#640)
Valid Range: 1 to 280 (#640) Pixels
This setting is applicable to SXGA mode only.
c8
SXGA Far Field Window
Horizontal Size
(farFieldDecodeWindowHeig
ht_pixels)
CR2500/CR3500:
400
(#1024)
Valid Range: 1 to 400 (#1024) Pixels
This setting is applicable to SXGA mode only.
c9
interleave2of5Lengths
0
FFFFFFFC: 2 and 4 digit disabled
FFFFFFFD: 2 digit enabled
FFFFFFFE: 4 digit enabled
Also see registers: 6e, 71
ca
Auto Disconnect
(autoDisconnect)
0
0: retain connection until sleep or explicit disconnect
command
1: disconnect from the Host when there is nothing to send. (In
conjunction with autoConnect (c6) and autoBufferUpload
(73), the Reader will connect when there is data to send,
send the data, then disconnect (to allow another Reader to
connect to the same Host).
cd
Codablock A Symbology
(enableCodablockA)
0
0: Disable
1: Enable
ce
Codablock F Symbology
(enableCodablockF)
0
0: Disable
1: Enable
cf
Macro PDF417 Symbology
(macroPdf417)
0
0: Disable
1: Enable
Also see registers: 29, 2a
d6
Ignore Duplicate Code
(duplicateBlockTime_sec)
0
Valid Range: 0 (off) to 7FFFFFF Seconds
Consecutive duplicate codes (i.e., codes that contain the same
data) are blocked for this amount of time (in seconds).
Note: Deprecated, but maintain for backwards
compatibility. If using 3430 or greater firmware, use register
159.
d8
Compostite Linkage Control
(compositeCodesRequireBot
hElements)
1
0: Accept any composite element
1: Only accept composite codes if both elements could be
decoded.
Also see register 4a.
d9
Max Connection Wait Time
(connectTimeout_sec)
1E
(#30)
Valid Range: 0 to 7FFFFFFF Seconds
The Reader will attempt connection for up to this amount of
time when a connection is explicitly requested, such as when
a QuickConnect code is read or an upload is requested (by
event or command).