User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 37 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
9f
Time in Standby Mode
(standbyTimeout_sec)
0
Valid Range: 0 to 7FFFFFFF Seconds
Standby Mode is the time between Idle Mode and Sleep
Mode. Standby Mode has lower power consumption but is in
a state very similar to Idle Mode.
Power usage: 2 out of 4
Communications: Disabled but the radio maintains its
connection (RF mode)
Previous state: Idle
Next state: Sleep
Note: supported in firmware version 2526+
Also see registers: 2c, 32, 88, 8e, 9e
a1
Vibrate
(vibrate)
CR2/CR3: 0
CR1200: 1
CR2500/3500: 1
0: Disable
1: Enable: vibrator will be on at same time as speaker
Note: if vibrate-only is desired, set speaker volume to 0.
a2
Default Event Delay
(defaultEventDelay_ms)
0
Valid Range: 0 to 7FFFFFFF Milliseconds
The Reader will pause for this amount of time between each
posting of the default event (used with “continuous read”
mode).
Also see register c4.
a7
Beep (Vibrate) Pulse
Separation
(beepSeparation_ms)
CR2/CR3: 14
(#20)
CR1200: 64
(#100)
Valid Range: 0 to 7FFFFFFF Milliseconds
The spacing in milliseconds between beeps.
Also see registers: 26, 59
ab
AGC Selection for Taking
Pictures
(useImagerAgcWithTakePict
ure)
0
0: use decoder AGC (designed for Symbology decoding)
1: use imager AGC (optimized for pictures)
Also see registers: 36, 43, ac, ad, ae, af, b1
ac
Picture Window Left
Position (pictureWindowX)
0
Specify position and size of window used with “take picture.”
The position and size are relative to the virtual image (i.e., not
the rotated physical image).
Note: on Code Reader 2, overall image is 1024 x 1280. Upper
half is far field; lower half is near field.
Also see registers: 36, 43, ab, ad, ae, af, b1
ad
Picture Window Upper
Position (pictureWindowY)
0
Also see register: ac
ae
Picture Window Width
(pictureWindowWidth)
CR2/CR3: 400
(#1024)
CR1200: 500
(#1280 )
Also see register: ac