User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 35 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
87
Motion Detection Sensitivity
(motionThresh)
CR2x: 19
(#25)
CR1200: F
(#15)
Valid Range:
The sensitivity of motion detection. Lower numbers make
detection more sensitive; higher numbers, less sensitive.
88
Time in Sleep Mode
(sleepTimeout_sec)
1C20
(#2*60*60
(7200 sec or 2
hours))
Valid Range: 0 to 7FFFFFFF Seconds
Sleep Mode is the time between Standby Mode and Power
Off Mode. The Reader can wake up out of Sleep Mode
without having to reboot resulting in a quicker transition to
Active Mode. Other than the quicker transition to Active
Mode and slightly higher power usage, the Reader is in a state
very similar to Power Off.
Power usage: 1 out of 4
Communications: Disabled
Previous state: Standby
Next state: Power Off (which uses no power)
Also see registers: 2c, 32, 8e, 9e, 9f
89
Bluetooth
®
PIN
(bluetoothPin)
12345678
(String)
Value of the Bluetooth
®
Pin sent if the Host requests a pin.
Note: See register 173
Note: Supported in firmware 3514+
8e
Time in Idle Mode
(idleTimeout_sec)
5A
(#90)
Valid Range: 0 to 7FFFFFFF Seconds
Idle Mode is the time between Active Mode and Standby
Mode. The Reader can transition to Active Mode very
rapidly. Other than the quicker transition to Active Mode and
slightly higher power consumption, the Reader is in a state
very similar to Standby Mode.
Power usage: 3 out of 4
Communications: Enabled
Previous state: Active
Next state: Standby
Also see registers: 2c, 32, 88, 9e, 9f