User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 33 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
55
Notify of No-Read
(notifyOfReadFailure)
0
0: Disable
1: send “r” packet on No-Read (See “r” packet in Section 5.2.)
0x100xx: post event on No-Read , where the lower 8 bits
specify the event number. For example, 0x10009 to post
Event 0x09.
The following example will use a stored code and stored code
event to output “No Read” on read failure.
B% 48%01X%1d%02>No%0dRead%00
P%5510048
Output when no decode was achieved:
No (%0d inserts carriage return)
Read
59
Beep/Vibration Duration
(beepDuration_ms)
CR2/CR3: 64
(#100)
CR1200: 50
(#80)
Valid Range: 0 to 7FFFFFFF Milliseconds
Also see registers: 26, a7
6a
UPC Symbology
(enableUpc)
1
0: Disable
1: Enable
Also see registers: 4d, 4e, 74
6b
Code 39 Symbology
(enableCode39)
1
0: Disable
1: Enable
Also see register: 70
6c
Code 93 Symbology
(enableCode93)
1
0: Disable
1: Enable
6d
Code 128 Symbology
(enableCode128)
1
0: Disable
1: Enable
6e
Interleave 2 of 5 Symbology
(enableInterleave2of5)
1
0: Disable
1: Enable
Also see registers: 71, c9
6f
Codabar Symbology
(enableCodabar)
1
0: Disable
1: Enable
70
Code 39 CheckSum
(code39Checksum)
0
Binary Dip Switch
Bit
Controls
Value
0 Code 39 Checksum Checking
0: Disable
1: Enable
1 Strip Checksum From Output
0: Disable
1: Enable
Also see register: 6b