User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 25 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
0b
Matrix 2 of 5 Symbology
(matrix2of5Options)
1
Binary Dip Switch
Bit
Controls
Value
0 Matrix 2 of 5 Decoding
0: Disable
1: Enable
1 Checksum checking
0: Disable
1: Enable
2 Strip checksum from the result
0: Disable
1: Enable
3 1 Digit Symbol Allowed
0: Disable
1: Enable
4 2 Digit Symbol Allowed
0: Disable
1: Enable
All symbol lengths greater than 2 are always enabled when
Matrix 2 of 5 Decoding is enabled
Note: Supported in firmware version 2378+
0c
Telepen Symbology
(telepenEnable)
1
0: Disable
1: Enable
0d
Enable Non-Square Data
Matrix Symbology
(enableNonSquareDataMatri
x)
0
0: Disable
1: Enable
Supported in firmware version 2378+
0f
Targeting Control
(targetEnable)
CR2/CR3: 3
CR1200: 3
(both bits
enabled)
Binary Dip Switch
Bit
Controls
Value
0
Green (CR1200)
Target (CR2/CR3)
0: Disable
1: Enable
1
Red (CR1200)
Target (CR2/CR3)
0: Disable
1: Enable
Note: Setting to 0 will disable all targeting features.
14
Image transform
(transformImage)
0
0: No transform
1: Mirror
2: Invert
16
Data Matrix Rectangular
Symbology
(dataMatrixRect)
0
0: Disable
1: Enable
19
Data Matrix Symbology
(enableDataMatrix)
1
Binary Dip Switch
Bit
Controls
Value
0 Data Matrix Decoding
0: Disable
1: Enable
1 Inverse Data Matrix Decoding
0: Disable
1: Enable