User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 24 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Reg
Setting Name
Default (hex)
Comment
05
No Wait USB
(usbKbEnumNotWaitForSet
ReportLed)
0
0: Default mode, declare enumeration after receive set LED
status report
1: Declare enumeration after receive get report descriptor
command. Used for some Windows CE based devices
Special case for USB enumeration that doesn’t require Host
keyboard response
Note: Supported in firmware version 2362+
06
Always Enable Auto White
Balance
(alwaysEnableAwb)
0
0: Disable
1: Enable
Auto White Balance
Note: Supported in firmware version 2378+
Note: Requires power cycle before taking effect.
07
kbSendDelay_kbClocks
0
Each keyboard clock period is 40 microseconds.
Note: Supported in firmware version 2378+
08
Reader Packet Format
(commProtocol)
1
0: Reserved
1: Raw
2: Packet mode
3: Reserved
09
Keyboard Inter-Message
Delay
(kbInterMessageDelay_ms)
0
Valid Range: 0 to 7FFFFFFF Milliseconds
Delay between each keyboard data transmit in the unit of
milliseconds
Note: Supported in firmware version 2378+
0a
NEC 2 of 5 Symbology
(nec2of5Options )
1
Binary Dip Switch
Bit
Controls
Value
0 NEC 2 of 5 Decoding
0: Disable
1: Enable
1 Checksum checking
0: Disable
1: Enable
2 Strip checksum from the result
0: Disable
1: Enable
3 1 Digit Symbol Allowed
0: Disable
1: Enable
4 2 Digit Symbol Allowed
0: Disable
1: Enable
Note: All symbol lengths greater than 2 are always enabled
when NEC 2 of 5 Decoding is enabled.
Note: Supported in firmware version 2378+