User manual

V002450_25_CR1200-CR2-CR3-CR2500-CR3500_Interface_Configuration_Document_CLIENT.docx
2011-04-27 Page 23 of 65
© 2011 The Code Corporation
• 14870 S. Pony Express Rd., Suite 200, Bluffdale, UT 84065 • [phone] • FAX [phone]
Given the settings above, the binary string to turn on NEC 2 of 5 decoding with checksum checking with
the checksum stripped from the result string, allowing 2 digit symbols is 10111 (bits left to right). The
same string would be 0x17 or decimal 23
Thus, the command to implement the settings above would be:
P(0a)17
Or
P(0a)#23
8.2 Reader Settings Table
Note: If only one default value is shown then this value is applicable and identical to both CR2/CR3
and CR1200. All differences in the settings use or default value will be noted.
Reg
Setting Name
Default (hex)
Comment
00
Bluetooth
®
Radio
Out-of-range
(enableRfDisconnectAlarm)
0
Binary Dip Switch
Bit
Controls
Value
0 Vibrate
0: Disable
1: Enable
1 Beep
0: Disable
1: Enable
Alarm when RF doesn’t have connection
01
Battery Trigger
(button8)
CR2/CR3: 4
CR2500/3500: 4
The event associated with the charge pin trigger. Used by the
BH1, BH2, and H2.
See register 39 for a list of event numbers.
Note: Supported in firmware version 2362+
02
Battery Trigger Confirmation
Time
(button8ConfirmationTime_
ms)
0
Valid Range: 0 to 7FFFFFFF Milliseconds
See register e3 for the list of settings.
Note: Supported in firmware version 2362+
04
Continuous Illumination
Leave illumination on during
read
(leaveIlluminationOnDuring
Read)
CR2/CR3: 0
CR1200: 1
0: Turn illumination off between read attempts
1: Leave illumination on between read attempts
Note: Supported in firmware version 2362+
Note: Obsolete for CR2/CR3 firmware 3430+