Instruction manual

1-30 Error no. H7700 *
1Error list
H7700 * Error message Illegal OPTION Slot No.(CC-Link)
Cause CC-Link Card is installed SLOT1/3.
Measures Install CC-Link Card in SLOT2.
H7710 * Error message Can't set the Master Station
Cause The CC-Link interface card of the robot cannot be set at the master station.
Measures Set the rotary switch except 0.
H7720 * Error message Plural CC-Link Cards are installed
Cause This card can install one.
Measures Use only one of these interface cards.
L7730 Error message CC-Link Data link error
Cause A communication line error has occurred, or parameter settings on the master station side are invalid.
Measures Check the wiring, or re-examine parameter settings on the master station side.
L7731 Error message CC-Link Data link error
Cause A communication line error has occurred, or parameter settings on the master station side are invalid.
Measures Check the wiring, or re-examine parameter settings on the master station side.
L7750 Error message (CC-Link)No connect cable or illegal parameter
Cause The cable is not connected, or parameter settings on the master station side do not match.
Measures Check the cable connection, or power off the system and then restart.
H7760 * Error message CC-Link initialization error
Cause The parameters in the master station do not match.
Measures Match parameter settings on the master station side, and then restart.
L7780 Error message Illegal CC-Link register number
Cause The register number entered was out of the range.
Measures Enter a correct register number according to the station number.
L7781 Error message INPUT signal No. is for CC-Link
Cause A CC-Link signal number was specified although no CC-Link interface was mounted.
Measures Install CC-Link card.
H7799 * Error message CC-Link System error
Cause CC-Link System error
Measures Contact the maker.
H7800 Error message Ethernet card initialization Err
Cause The Ethernet card is broken.
Measures Check the Ethernet board.
H7802 * Error message Illegal OPTION Slot No. (Ether)
Cause Ethernet Card is installed SLOT2/3.
Measures Install the Ethernet Card in SLOT1.
H7803 * Error message Plural ethernet cards are installed
Cause This card can install one.
Measures Use only one of these interface cards.
H7810 Error message Ethernet NETIP parameter ERR
(NETIP,NETGW,NETPORT,NETPROC,NETLOGIN,NETPSSWD,NETTOUTR,NETTOUTS,MXTCOM1-3)
Cause Parameter settings are incorrect.
Measures Correct the parameters.
H7820 Error message MXT/MXScommand timeout
Cause The setting time of the MXTTOUT parameter has been exceeded.
Measures Make the MXTTOUT parameter value larger.
H7830 Error message "Ethernet card is not installed, or command disable"
Cause Ethernet card is not installed, or command disable.
Measures Install Ethernet interface card.
Error No. Error cause and measures