Instruction manual

1Error list
Error no. H7600 * 1-29
H7600 * Error message Illegal parameter (AXMENO)
Cause The additional axis mechanism No. is incorrect.
Measures Correct parameter AXMENO and AXUNUM.
H7601 * Error message Illegal parameter (AXJNO)
Cause The additional axis No. is incorrect.
Measures Correct parameter AXJNO.
H7602 * Error message Duplicate parameter (AXJNO)
Cause The additional axis No. has been used in duplicate.
Measures Correct parameter AXJNO.
H7603 * Error message Illegal parameter (AXUNT)
Cause The additional axis unit is incorrect.
Measures Correct parameter AXUNT.
H7604 * Error message Illegal parameter (AXACC)
Cause The additional axis acceleration time is incorrect.
Measures Correct parameter AXACC.
H7605 * Error message Illegal parameter (AXDCC)
Cause The additional axis deceleration time is incorrect.
Measures Correct parameter AXDEC.
H7606 * Error message Illegal parameter (AXGRTN)
Cause The additional axis gear ratio numerator is incorrect.
Measures Correct parameter AXGRTN.
H7607 * Error message Illegal parameter (AXGRTD)
Cause The additional axis gear ratio denominator is incorrect.
Measures Correct parameter AXGRTD.
H7608 * Error message Illegal parameter (AXMOTSET)
Cause The additional axis motor setting validity flag is incorrect.
Measures Correct parameter AXMOTSET.
H7609 * Error message Illegal parameter (AXMREV)
Cause The additional axis motor rated speed is incorrect.
Measures Correct parameter AXMREV.
H7610 * Error message Illegal parameter (AXJMX)
Cause The additional axis motor limit speed is incorrect.
Measures Correct parameter AXJMX.
H7611 * Error message Illegal parameter (AXENCR)
Cause The additional axis No. of encoder pulses is incorrect.
Measures Correct parameter AXENCR.
H7612 * Error message Illegal parameter (AXJOGTS)
Cause The additional axis JOG time constant is incorrect.
Measures Correct parameter AXJOGTS.
H7613 * Error message Turn the power OFF and ON once
Cause It is necessary to turn the power ON again because user mechanism setting has been performed.
Measures Turn the power OFF and ON once.
H7620 * Error message Plural Add-AxisI/F are installed
Cause This card can install one.
Measures Use only one of these interface cards.
C7630 Error message No additional-axis card
Cause No additional-axis card
Measures Install the additional axis interface card.
Error No. Error cause and measures