Instruction manual

1Error list
Error no. C7020 1-27
C7020 Error message Rename target file was not found
Cause The rename target file was not found.
Measures Input the correct file name.
H7030 * Error message System error (param size over)
Cause The change capacity is too large.
Measures Contact the maker.
C7040 Error message Parameter changes prohibited
Cause Changing this parameter is prohibited as it is a dangerous parameter.
Measures Contact the maker.
H7050 Error message File is illegal
Cause This file is damaged.
Measures Contact the maker.
H7060 * Error message System error (RAM area full)
Cause The capacity has been exceeded.
Measures Contact the maker.
C7070 Error message Memory area is full
Cause The program and data have already exceeded the capacity.
Measures Delete any unnecessary programs or data.
L7071 Error message Not enough memory area for CTN
Cause Continue function needs more than 100Kbytes memory area.
Measures Delete any unnecessary programs.
C7080 Error message Can not read parameter
Cause Non-existent parameter or illegal password.
Measures 1. Input the correct parameter name 2. Input the correct password
C7081 Error message Can not write parameter
Cause Non-existent parameter or illegal password.
Measures 1. Input the correct parameter name 2. Input the correct password
C7090 Error message Parameter comment illgal
Cause The number of parameter comment characters exceeded the limit.
Measures Operation will not be affected, so continue the operation.
C7100 * Error message Add memory has not enough.
Cause Data is left in the extended memory.
Measures Perform program initialization using the TB to clear all data.
C7200 * Error message Add memory has same file.
Cause Add memory has same file name.
Measures Perform program initialization using the TB to clear all data.
H7300 * Error message Loading the parameter file.
Cause It is necessary to turn the power ON again to reflect the parameters.
Measures Turn the power OFF and ON once.
C7310 Error message Changed variables weren't saved
Cause The power was OFF during program execution.
Measures Don't turn the power OFF during program execution.
L7311 Error message The power was OFF during file saving
Cause The power was OFF during file saving.
Measures Don't turn the power OFF during file saving.
L7330 Error message Can't change in RAM mode
Cause When in RAM mode, the language selection (RLNG) and the enable/disable setting of continuity (CTN)
cannot be changed.
Measures Please change to RAM mode and perform again.
Error No. Error cause and measures