Installation guide

Tach Programming

The unit will not operate unless tach is programmed or tachless option is

turned ON.Ifanattemptismadetostartthevehicleviatheremotestartwithoutrst

programmingtach,theunitwillashtheparkinglights7timesindicatingtachhasnot

beenlearnedandstored.Ifthetachrateisnotproperlyprogrammedtothespecic

vehicle, the unit may not realize that the vehicle is running in certain instances and

re-engage the starter motor.

The Remote Start unit will learn the tach rate of most vehicle’s single coil, multiple coil

packs, or single injector. To learn tach:

1. Turn the ignition key to the ON position.

2. Press and release the valet/override button 3 times.

3. Immediately turn the ignition key OFF.

4. Press and hold the valet/override button, then start the vehicle using

the key.

5. When the unit senses the tach signal, the parking lights will begin to

  ash.

6. Allow the vehicle to settle to a normal idle speed.

7. Release the valet/program push-button switch. The parking lights will

turn on for 2 seconds and 1 long chip will indicate that the learned

tach signal is stored and the unit has exited tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tach connection or a

poortachsource,theparkinglightswillnotash.Tocorrectthissituation,locateand

connect the PURPLE/WHITE wire to the proper tach signal, and then repeat the tach

learn routine.

Smart Tachless Mode

Smart Tachless Mode is available only if a tach signal has never been learned to the

system and when activated will automatically change the Tach Mode feature in option

programming to Tachless without the need to enter the feature programming mode.

  1. Activatetheremotestart.Theparkinglightsshouldbeginashing7

times indicating no tach signal has been learned.

  2. Withinthe7ashtimeperiod,pressandholdthe button.

3. The system will chirp 1 time indicating the system is now in tachless

mode.