Installation guide
14 ca6554 Install revA
4 Pin Alternate Output Harness
1 LT GREEN/BLACK FACTORY DISARM /
PULSE BEFORE START ( - )
This wire will supply a ( - ) 200mA pulse both upon disarming the system and when
the remote start feature is activated. Locate the factory perimeter alarm disarm wire
from the key cylinder inside the drivers door.
Verication: This wire registers ground if the key is turned to the unlock
position in the driver’s door cylinder.
Thisoutputcanbeconguredinoptionprogramming.
2 LT BLUE FACTORY ARM /
PULSE AFTER START ( - )
This wire will supply a ( - ) 200mA pulse both upon arming the system and upon
successful completion of the remote start activation sequence and is typically used to
re-lock the vehicle’s doors upon remote start if necessary.
Thisoutputcanbeconguredinoptionprogramming.
4 BLACK/YELLOW PULSE DURING CRANK ( - )
Locate the vehicle’s second starter (crank) wire at the ignition switch. (if equipped)
Verication: This wire registers voltage only in the start (crank) position of
the ignition switch.
Thiswirewillsupplya(-)200mAoutputandcanbeconguredinoption
programming.
3 GREEN/WHITE PULSE AFTER SHUTDOWN ( - )
This wire will supply a ( - ) 200mA pulse after the remote start shuts down. This
is typically used to re-lock the vehicle’s doors if they unlock upon remote start
shutdown. It can also be used to pulse a door pin-switch wire to prevent the vehicle’s
accessories from remaining on after remote start shutdown.
Thisoutputcanbeconguredinoptionprogramming.