Installation guide

128-6531

9 of 24

Orange: Ground When Armed Output

This wire provides a 300mA ground output when the alarm is armed to control the starter kill relay. Connect

the Orange wire to terminal #86 (orange wire) of the relay provided. Connect terminal #85 (red wire) of the

relay to an ignition wire in the vehicle that is +12 volts when the ignition switch is turned to the ON and

START positions and off when the key is OFF. Locate and cut the low current start solenoid wire found at the

vehicles ignition switch harness. This wire will have + 12 volts when the ignition key is moved to the START

(crank) position and will have 0 volts in all other key positions. Connect one side of the cut wire to terminal

#87a (Black wire) of the relay. Connect the other side of the cut wire to terminal #30 (White/Black wire) of the

relay. See below for detail of wiring, also see Violet Start wire detail for connection to vehicle considerations.

Brown: Positive Brake Input

Any time +12 Volts is applied to the Brown wire, the system will stop operating, even if the signal is received

from the transmitter. If the brake light switch in the vehicle switches +12 Volts to the brake light circuit, connect

the Brown wire to the output of the brake light switch. If the brake light switch in the vehicle switches ground,

do not use the Brown wire; see Grey w/ Black wire.

Black

White/Black