Installation guide

128-6531

8 of 24

Black w/ White: Illuminated Entry Output

This wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to disarm the

system or to unlock the doors and provides a continuous pulsed output whenever the system is triggered.

This wire should be connected to an external relay, and wired to the vehicles interior entry lighting

whenever the optional Interior Illumination circuit is desired. See below for relay wiring details.

GREY: Hood Pin Input (-)

Connect the GREY wire to the hood pin switch provided . This wire will be routed through the firewall into the

engine compartment. It is necessary to use an existing grommet when passing wires through the firewall to

prevent short circuiting. This is an important safety feature of CA-610, and failure to use this feature can result

in serious injury. Route the wire to the pin switch and connect it using the bullet connector provided.

Black w/White trace