Installation guide

128-6531
20 of 24
23
PROGRAMMING TRANSMITTERS:
It is important to remember that during the programming mode, each individual step must be completed within
15 seconds of the previous step. If the 15 second time limit expires between steps, the system will
automatically exit the program mode. This is indicated by a long chirp from the siren.
TO PROGRAM ADDITIONAL TRANSMITTERS:
1. Enter the vehicle, and turn the ignition switch to the ON position.
2. Press and release the valet push button switch 3 times.
3. The dash mounted LED will flash 1 time, and the siren will chirp 1 time, indicating that the system is ready
to accept programming of channel #1 which is arm/lock.
4. Press and hold the LOCK symbol button of the transmitter you wish to program for 4 seconds or until a long
chirp is heard from the siren.
"Repeat step 4 for each transmitter you wish to program"
5. Press and release the valet push button switch 1 time to advance to Unlock. The siren will chirp 2
times and the dash mounted LED will Flash 2 times, indicating that the system is ready to accept
programming for channel # 2 which is for disarm/unlock
6. Press and hold the unlock symbol button of the transmitter you wish to program for 4 seconds or until a long
chirp is heard from the siren.
"Repeat step 6 for each transmitter you wish to program"
7. Press and release the valet push button switch 1 time to advance to channel 3. The siren will chirp 3
times and the dash mounted LED will Flash 3 times, indicating that the system is ready to accept
programming for channel # 3 which is the trunk release and start output channel of the system.
8. Press and hold the trunk/key symbol button of the transmitter you wish to program for 4 seconds or until a
long chirp is heard from the siren.
"Repeat step 8 for each transmitter you wish to program".
9. Press and release the valet push button switch 1 time to advance to channel 4 if so equipped. The siren
will chirp 4 times and the dash mounted LED will Flash 4 times, indicating that the system is ready to
accept programming for channel # 4, optional device.
10. Press and hold the Option button of the transmitter you wish to program for 4 seconds or until a long chirp
is heard from the siren.
"Repeat step 10 for each transmitter you wish to program"