Installation guide

128-6531

17 of 24

6. Use the lock/arm button on the transmitter to advance to the feature you want to change. EXAMPLE- If

you need to change selectable feature 3, press and release the lock/arm button on the transmitter 3

times in succession. The parking lights will flash, and the siren will chirp 3 times confirming that

selected feature 3 can be changed.

7. Use the trunk/key button on the transmitter to change the selection of the programmable feature. If you

are not sure what the setting for any feature is, press the trunk/key button one time, the parking lights will

flash 1, 2, 3 or 4 times indicating the features setting.

NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps,

or the programming mode will be terminated.

TACH PROGRAMMING:

The Remote Car Start will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or

single injector. To learn tach:

1. Turn the ignition key to the ON position.

3. Press and release the program switch 3 times.

4. Immediately turn the ignition key OFF.

5. Hold the program switch ON, then start the vehicle using the ignition key

6. When the unit senses the tach signal, the parking lights will begin to flash.

7. Release the program switch. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored

and the unit is now out of the program mode.

DIAGNOSTICS:

1. Be sure that programmable feature number #7 is set to the "Diagnostics On" mode.

2. Press and hold the program switch on, then turn the ignition key to the ON position.

3. The lights will flash and the number of flashes will indicate the reason for shutdown on the last remote start

attempt. The indications are as follows.

1 Flash 5, 10, 15, or 20, minute run timer expired.

2 Flashes Low or No tach signal received.

3 Flashes Positive or Negative input shut down.

4 Flashes Control switch was moved to OFF position.

5 Flashes RF Shutdown command received.

6 Flashes High RPM signal over speed shut down.

7 Flashes Tach has NOT learned.