Installation guide

128-6531

16 of 24

To program these selectable features:

Turn ignition ON press and release the valet switch 3 times. The system will chirp 1 time and the LED will

flash once. Within 3 seconds, turn ignition OFF. The system will sound a short chirp, then 1 long chirp

1. Turn the ignition key to the ON position.

2. Press and release the program switch 3 times. The siren will chirp 1 time and the LED will flash once.

3. Immediately turn the ignition key OFF. The siren will sound a short chip and then 1 long chirp.

4. Use the program switch to advance to the feature that you want to change.

5. Press the LOCK button to change the selection of the programmable feature.

Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between

steps, or the programming will be terminated.

REMOTE START SELECTABLE FEATURES:

Feature Lts Flash 1X Lts Flash 2X Lts Flash 3X Lts Flash 4X Default

1. Start Chirps Off On On

2. Run Time 5 Min. 10 Min. 15Min. 20 Min. 10 Min

3. Park Lights On Flash On

4. Tach Mode Tachless Tach

5. Voltage Level > .5V B4 start < .5V B4 start > 0.5

6. Ign. 2 Off during start On during start On

7. Diagnostics Off On Off

8. Start Time 0.8Sec 1.0 Sec 1.5 Sec 2.0 Sec 1.0

9 Gas/Diesel Diesel 10 Diesel 15 Diesel 20 Gas

o Program The Remote Start Selectable Features:

1. Turn the ignition key to the ON position.

2. Press and release the valet/program switch 3 times.

3. Immediately turn the ignition key OFF then press transmitter trunk/key button for 1 second.

4. Immediately turn the ignition key back ON..

5. Press and release the valet/program switch 2 times. The siren will emit 2 short and 1 long chirp verifying

you are in the feature program mode.