Installation guide

128-6531
14 of 24
15
The Blue/Red wire provides a pulse ground output when the unlock button of the transmitter is pressed a second
time after disarming. Connect the Blue/Red wire to the wire that provides a low current ground signal from the
factory door unlock switch to the factory door unlock control relay.
3 Wire Positive Switched 2 Step Door Locks
The BLUE wire provides a positive pulse during arming, or the pulsed + 12 volt lock output. Connect the green
wire to the wire that provides a low current positive signal from the factory door lock switch to the factory door
lock control relay.
The GREEN wire provides a positive pulse during disarming, or the drivers door pulsed positive unlock output.
Connect this wire to the drivers door unlock relay that requires a low current positive signal to unlock only the
drivers door. If the vehicle does not have a separate drivers door relay, one will have to be added. Locate the
drivers door unlock motor wire and cut it at a convenient location to allow wiring of an optional relay. Connect
the door side of the cut wire to terminal 30 of the optional relay added. Connect the vehicle side of the cut wire to
terminal 87a of the optional relay added. Connect the red wire of the 3 pin harness to terminal 86 of the optional
relay added. Connect terminal 85 of the optional relay added to chassis ground. Most vehicles door lock/unlock
motor legs rest at ground, and switch +12 volts to the door lock/unlock motor wire for operation, if this is the case
in the vehicle you are working on, connect the remaining terminal, 87, to a fused + 12 volt source. In the rare
instance that the vehicle door lock/unlock motor wire rest at + 12 volts and switches ground to the door lock/
unlock motors, connect he remaining terminal, 87, to chassis ground.
The Blue/Red wire provides a pulse ground output when the unlock button of the transmitter is pressed a second
time after disarming. Because the vehicle you are working on requires a positive pulse from the factory door lock
switch to the factory door lock control relay, you will have to add a relay to invert the output polarity of this wire.
Connect the Blue/Red wire to terminal 86 of the optional added relay. Connect terminal 85 & 87 to a fuse + 12
volt source. Connect terminal 30 to the low current door unlock wire from the factory door switch to the door
unlock control relay.
Green
Blue/Red
Blue