Installation guide

128-6531
12 of 24
13
2 Pin Control Switch: (Red Connector)
The Black & Black/White wires loaded in the two pin red connector enable the operation of the Remote Start
system. When the Black w/ White wire is grounded, the Remote Start system is operable. When this wire is open
from ground, the Remote Start is disabled. Route the twin lead Black & Black/ White wires from the control
switch to the Remote Start system and plug red two pin connector into the mating red two pin connector shell of
the control module.
4 Pin Shock Sensor: (White Connector)
The Red (+12 volt), Black (ground), Blue (pre-detect) and Green (full trigger when armed) wires loaded into the
white connector shell are the inputs/outputs of the shock sensor. Route the 4 wire harness from the shock
sensor to the system and plug the 4 pin white connector into the mating 4 pin connector shell of the control
module.
2 Pin LED Harness: (White Connector)
The Red & Blue wires loaded into the two pin mini white connector control the anode and cathode of the dash
mounted LED. Route the twin lead Red and Blue wires from the LED to the system and plug the two pin
connector into the mating white mini connector.
2 Pin Valet/Program/Override Push-Button Switch: (Blue Connector)
The Black & Grey twin lead wires loaded in the two pin blue connector are the ground supply and program/valet/
override input of the system. When the Grey wire is grounded, under certain conditions, the system will enter the
valet mode. When the Grey wire is sequentially grounded under other conditions, the system will enter the
various program modes. Route the twin lead Black and Grey wires from the valet/Program switch to the Remote
Start system and plug the two pin connector into the mating blue connector. Refer to the remote programming,
feature programming and function programming shown later in this installation guide for operation of the valet/
program switch.
3 Pin Antenna/Receiver Connector: (White Connector)
Plug the previously routed three pin connector from the antenna receiver assemble into the mating connector of
the control module. This connector supplies 12 volts, ground and RF data from the antenna receiver to the
remote start module. Be certain this connector is firmly seated making good contact to the control system.
3 Pin Door Lock/Unlock Harness: (White Connector)
The Blue and Green wires will provide either a pulsed ground output to the factory door lock control relay, or a
pulsed +12 volt output to the factory door lock control relay. In either case, the maximum current draw through
these outputs must not exceed 300mA. The Blue/Red wire will provide a pulsed ground only, and will only
provide an output when the unlock button of the transmitter is pressed a second time after a first unlock
command was issued. This is used for second step unlock or all doors unlock in a two step circuit. In this
arrangement, BLUE is used to control the drivers door unlock relay, and the Blue w/Red will be used to control
unlock of all other doors.