Installation guide

128-6531
11 of 24
RED/WHITE: 300mA Latched Channel 4 Output
The Red/White wire supplies a 300mA switched output whenever channel 4 of the system is accessed.
Pressing the pre-programmed transmitter button will access channel 4 and will remain active, for up to 8
seconds, as long as the transmitter button is held. This is a low current output and must be connected to a
relay to supply power to the device you intend to control. Connect Red w/White Trace wire to terminal #86 of a
30 Amp automotive relay or equivalent. Connect terminal #85 of the relay to a fused + 12 volt source. Connect
the common, normally open, and normally closed contacts of the relay to perform the selected function of the
channel 4 output.
DARK BLUE: External Trigger Input
The Dark Blue wire allows the Remote Start system to be activated from an external source. The intent of this
wire is to allow the system to be controlled from a "POSSE/CAR-LINK" paging system or similar device. When
this wire receives a ground pulse, the system will start the vehicle.
BROWN/BLACK : 300 mA Horn Output
The Brown/Black wire is provided to honk the vehicle’s horn. This is a transistorized low current output, and
should only be connected to the low current ground output from the vehicle’s horn switch. If the vehicle uses a
+12 VDC horn switch, then connect the Brown/Black wire to terminal 86 of the 30 Amp automotive relay, and
connect relay terminal 85 to a fused + 12 VDC battery source. Connect relay terminal 87 to the vehicle’s horn
switch output, and connect relay terminal 30 to a fused + 12 VDC battery source.
WIRING THE 4 PIN HARNESS:
This harness provides low current outputs to control various functions in the vehicle during different stages of
the Remote Start system's operation. Understanding these outputs and the time in which they occur will allow
you to determine if they are needed for the particular vehicle you are working on, as well as how to use them.
GREEN/BLACK Pulsed Ground Output Before Start
The Green w/Black wire will provide a 1 second 300mA pulsed ground output 1.5 second before the Remote
Start system activates as well as when the transmitter is used to unlock/disarm the system. Typical use for this
output would be to disarm a factory theft deterrent system to prevent false triggering of the factory alarm when
the remote start system engages.
BLUE: Pulsed Ground Output After Start
The Blue wire will provide a 1 second 300ma pulsed ground output after the vehicle is started under control of
the Remote Start system. Typically this wire will be used to re-lock the vehicle doors if the doors unlock
automatically when the factory anti-theft system is disarmed.
BLACK/RED Pulsed Ground Output After Shutdown
The Black w/ Red wire will provide a 1 second 300 mA pulsed ground output after the Remote Start system
shuts down. This output will occur regardless of whether the circuit times out or is manually terminated.
Typically this output will be used to re-lock the vehicle doors if the doors unlock automatically when the ignition
circuit transitions to off.
BLACK/YELLOW: Ground Output During Start (Crank)
The Black w/ Yellow wire will provide a 300mA ground output while the starter output of the Rremote Start
system is active. This output can be used to activate the Bulb Test wire found in some GM vehicles.
12