Owner's Manual

6 Pin Start
Harness
1
PURPLE STARTER
OUTPUT
( + )
Locate the vehicle starter wire.
Verification:
This wire registers voltage
only
when the key is turned
to
the
START position.
Verification:
The starter wire registers voltage when the
key
is turned to the
START position.
Connect the PURPLE wire to the vehicle starter wire.
2 RED BATTERY
12V
(
+)
Locate 1
of
the vehicle's constant 12 Volt battery wires
at
the ignition switch.
Verification: This wire will register ( + ) voltage in all positions
of
the ignition
switch.
Connect
the
RED wire to the constant 12 Volt battery wire.
NOTE:
Remove
all
fuses until
all
connections are made.
3
ORANGE
ACCESSORY
1 ( + )
Locate the vehicle's accessory wire at the ignition switch.
Verification: This wire registers voltage when the key is turned to
ACC
(Accessory) and the
ON
(or RUN) position.
The
voltage
drops
out
when
the
key is turned to the
START
(or CRANK) position.
Connect the
ORANGE
wire to the vehicle's accessory wire.
Programmable output:
IGN, ACC,
Start.
4
PINK/WHITE IGNITION 2 ( + )
Locate the vehicle's 2nd ignition wire at the ignition switch (if equipped).
Verification: This wire registers voltage
when
the key is turned to
the
ON
(or
RUN) position, but not the
ACC
(Accessory) position.
The
voltage
does
not
drop
out
when the key is turned to the
START
(or
CRANK)
position.
Connect
the
PINK/WHITE
wire to the vehicle's ignition 2 wire.
Programmable output:
IGN, ACC,
Start.
2014 Voxx Electronics Corporation. All rights reserved.
9