Owner's Manual

7
BLUE/BLACK
START
STATUS
I
ACTIVE OUTPUT ( - )
This wire provides a ground output when the remote start function is activated and
remains until 4 seconds after the remote start
is
shutdown.
If
this wire
will be used
for multiple application's a 1 amp diode is required in-line with the stripe facing the
control module.
8
PURPLE/WHITE
TACH
INPUT
Locate the vehicle's ignition coil or fuel injector
in
the engine compartment.
Verification:
Test using the
following
procedure:
1.
Set
voltmeter to
AC VOLTS.
2.
Attach positive lead
of
a volt meter to a constant 12-volt source.
3.
Attach negative lead
of
a volt meter to the wire to be tested.
4.
Start the engine.
5.
Have someone press on the gas pedal slightly as you monitor the meter.
If
connected to the correct wire, the voltage reading
will increase as the engine's
RPM increases.
Connect the PURPLE/WHITE wire to the negative side
of
the vehicle ignition coil
or
fuel injector.
9
GRAY
HOOD
PIN
INPUT ( - )
Install
a Hood Pin Switch and connect to the GRAY wire. This connection is required
for Remote Start.
Verification:
This wire when connected
will
register ground when the
vehicle's
hood
is
opened.
Connect the GRAY wire to the hood pin.
NOTE:
Be sure to loom the wire, and seal the grommet.
1
0 BROWN/RED
BRAKE
INPUT (
+ )
Locate the vehicle's brake light wire at the brake pedal mounted switch. This
connection
is
required for Remote Start.
Verification:
This wire registers positive voltage when the brake pedal is
pressed.
Connect the BROWN/RED wire to the vehicle's brake light wire.
2014
Voxx Electronics Corporation. All rights reserved.
7