Owner's Manual

24
3-
Running Lights:
Controls the WHITE
parking light
output wire during remote
start.
Steady - Parking
lights
constant during the remote start
cycle.
Flashing-
Parking lights flash at a
slow pace during the remote start cycle.
4 - Tach Mode:
Determines how the system monitors the engine running during
remote start.
Tach-
Hard wired
directly
to the tach wire of the
vehicle
to monitor
AC
voltage.
Tach
less (Crank Average/Voltage)- Determines crank time by averaging the
last
8 times the
vehicle
was started with the key and then monitors the
change
in
voltage after remote start.
Hybrid (Crank Average
I
No Voltage)-
Determines crank time by averaging
the
last
8 times the
vehicle
was started with the
key.
OBI
Port - Monitors the
vehicle's
tach rate through
an
interface
module
connected to the
OBI
port.
5-
Voltage Level:
The
voltage
variance for remote start when set to tach
less.
(see
tach mode)
HIGH
-The
variance
in
battery voltage from before the remote start
is
activated to after the engine is running must be greater than
0.5 volts.
LOW
- The variance
in
battery
voltage
from before the remote start
is
activated to after the engine is running may be
less
than
0.5 volts.
6 - Crank Time:
Preset output times for the PURPLE starter wire.
1 Second
0.8
Seconds 1.5 Seconds 2 Seconds 4 Seconds
7 - Crank Average
I
Crank Time:
The
length
of
time
in
which the remote start
will
crank the
vehicle's starter.
Crank Average - Determines crank time by averaging the
last
8 times the
vehicle
was started with the
key.
Preset
Time-
Preset starter output time. (see crank time)
ca5554
Install
rev A