Owner's Manual

Tach Programming
The unit
will
not operate unless
a tach
signal
is
programmed or the tach
less
option
is
turned ON.
If
an
attempt is made
to
start the
vehicle
via the remote start
without first programming tach, the unit
will flash the parking
lights 7 times indicating
tach has not been
learned
and stored.
If
the tach rate
is
not
properly
programmed
to
the specific
vehicle,
the unit may not
realize
that the
vehicle is running
in
certain
instances and reengage the starter motor.
The Remote
Start unit
will learn
the tach rate of most
vehicle's single coil, multiple coil
packs, or
single
injector.
To
learn
tach:
1.
Turn the ignition key to the
ON
position.
2.
Press and
release
the
valet/override
button 3 times.
3.
Immediately
turn the ignition key
OFF.
4.
Press and hold
the valet/override
button, then start the
vehicle
using
the
key.
5.
When the unit senses the tach
signal,
the parking lights will
begin to
flash.
6.
Allow the vehicle to settle
to a normal idle
speed.
7.
Release
the valet/program
push-button switch. 1
long chirp and the
parking lights will
turn on for 2 seconds, indicating that the
learned
tach
signal
is stored and the unit has exited tach
learn mode.
NOTE:
If the unit
fails
to
learn
tach rate due
to
an
improper tach connection or a
poor tach source, the parking
lights will
not
flash.
To
correct this situation,
locate
and
connect the
PURPLE/WHITE
wire to the proper tach
signal,
and then repeat the tach
learn
routine.
Smart
Tach
less
Mode
Smart Tachless Mode is available only
if a tach signal
has never been
learned
to the
system and when activated will automatically change the
Tach
Mode feature
in
option
programming to Tachless without the need
to
enter the feature programming mode.
1.
Activate the remote start. The parking
lights should
begin
flashing
7
times indicating no tach
signal
has been
learned.
2.
Within the 7 flash time period, press and
hold
the
()
button.
3.
The system will
chirp 1 time indicating the system is now
in
tachless
mode.
20
ca5554
Install
rev
A