Owner's Manual

Additional
Ports
Antenna
I
LED
I
Programming Port
Mount the supplied antenna/receiver to a
clear
spot
on
the
vehicle's windshield that
will
not block
the driver's vision. A good
location
is
usually high on the windshield
near the rear view mirror.
Be
careful
not
to
mount the antenna/receiver on any
metallic window film,
as this
will effect
system range. Route the antenna/receiver
cable
to the control module
and
plug
into the antenna port.
Data Bus
Interface
Port
This 4 pin port is used for
Flashlogic
Door Lock and Transponder Databus
Interfaces
to communicate with the
vehicle's Databus. When using the
OBI
port to
control the
Flashlogic
Door Lock and Transponder
Interface modules the following
options may
be
available. Please
refer to the
020
(Data to Data) function
list available
per
vehicle
on the tech service web site.
Tach
Input
Trunk/Hatch
Open
Door Lock
Control
Dome Light Supervision
Factory
Alarm
Arm
I
Disarm
Telematic Interface Port
Brake
Safety Shut
Down
Diesel Glow Plug Input
Passlock
I Passkey Interface
(GM
Only)
Transponder Interface
Activation
Manual Arm
I
Disarm
Inputs
(factory
keyless
controls
system)
This 4 pin port is used for
Telematic Interface accessories, such as
Car
Connection
Pro, which can
control
some of the following
features.
Door Lock Control
Trunk
Release
Sliding
Doors AUX
Output
Car
Find Remote Start
2014
Voxx
Electronics
Corporation.
All
rights reserved. 15