Owner's Manual

10
5
RED/WHITE BATTERY 12V (
+)
Locate 1
of
the vehicle's
constant 12 Volt battery wires at the ignition switch.
Verification:
This wire
will
register (
+ )
voltage in
all
positions
of
the ignition
switch.
Connect the
RED/WHITE
wire to the constant 12
Volt battery wire.
NOTE:
Remove
all
fuses
until all connections are made.
6
PINK
IGNITION
1
( + )
Locate the
vehicle's
ignition wire at the ignition switch.
Verification:
This wire registers voltage
when the key is turned to the
ON
(or
RUN) position. The
voltage does not drop out when the key is turned to the
START (or CRANK) position.
Connect the
PINK
wire to the
vehicle's Ignition
wire.
This wire is
also
used for
Ignition 1 Output.
4 Pin
Alternate
Harness
1
BLACK/YELLOW
PULSE
DURING
CRANK
(-)
Locate the
vehicle's second starter (crank) wire at the ignition switch. (if equipped)
Verification:
This wire registers
voltage only
in the start (crank) position
of
the ignition switch.
This wire will supply
a
(-)
200mA
output and can be configured in option
programming.
2
GREEN/WHITE PULSE
AFTER
SHUTDOWN
( - )
This wire
will supply
a
(-)
200mA pulse
after the remote start shuts down. This
is
typically
used to
re-lock
the
vehicle's
doors if they
unlock upon remote start
shutdown.
It
can
also
be used to
pulse
a
door
pin-switch wire to prevent the
vehicle's
accessories from remaining on after remote start shutdown.
This output is configurable
in option programming.
ca5554
Install
rev A