Installation guide
6 Pin
Start
Harness
1
PURPLE
STARTER OUTPUT (
+ )
Locate the vehicle starter wire.
Verification:
This wire registers voltage
only
when the key is turned to the
START position.
Verification:
The starter wire registers voltage when the key is turned to the
START position.
Connect
the
PURPLE
wire to
the
vehicle starter wire.
2
RED BATTERY 12V (
+ )
Locate 1 of the vehicle's constant 12 Volt battery wires at the ignition switch.
Verification:
This wire
will register (
+ )
voltage
in
all
positions of the ignition
switch.
Connect the RED wire to the constant 12 Volt battery wire.
NOTE:
Remove
all
fuses until
all
connections are made.
3
ORANGE
ACCESSORY 1
(
+ )
Locate the vehicle's accessory wire at the ignition switch.
Verification:
This wire registers voltage when the key is turned to ACC
(Accessory) and the
ON (or RUN) position. The voltage drops out when the
key is turned to the START (or CRANK) position.
Connect the ORANGE wire to the vehicle's accessory wire.
4
PINK/WHITE
IGNITION
2
(
+ )
Locate the vehicle's 2nd ignition wire at the ignition switch (if equipped).
Verification: This wire registers voltage when the key is turned to the ON
(or
RUN) position, but not the
ACC
(Accessory) position. The voltage does not
drop out when the key is turned to the START (or CRANK) position.
Connect
the
PINK/WHITE
wire
to
the
vehicle's
ignition
2
wire.
Programmable output:
IGN, ACC,
Start.
2012
Audiovox
Electronics
Corporation.
All
rights reserved.
9